Gently pull away as much loose seam as possible.
Carpet coming away from gripper.
Apply it to the backing of one edge of the carpet between the pile and the pad.
When you can permanently fix the problem use pliers to lift and remove the staples.
The older a carpet gets the less flexibility it has and the less likely it will engage with the rods.
Carpet suppliers and some hardware stores sell carpet seam adhesive.
Place staples at the back or ends of tread to avoid stepping on exposed heads.
Crazydaze 5 jul 2014.
First go to the corner nearest the wet area grab the carpet with pliers and pull the carpet off the tack strip.
Yes they have used the wrong gripperrods you can get short medium and long pin gripper.
The gripper rods have outward facing teeth so the carpet needs to be pushed past the teeth to allow the teeth to bite as the carpet pulls back.
Leave a space between the gripper and the wall that is lightly less than the thickness of your carpet but no more than 3 8 inch wide so that the trimmed carpet can be tucked in later to hide the.
Depending on the age and condition of your carpet it may well just be a lift re stick and refit.
See below for a shopping list and tools subscribe to this old house.
Wet carpet pad is like a big sponge.
Most carpet fitters now opt to stick the grippers with a strong adhesive rather than just relying on the nails alone.
Medium is ok for 90 of carpets dont let them bash the pins down as that will lock the carpet on to them.
Apply seam adhesive as directed by the label.
Here is a typical method.
If its a concrete stone floor the problem may lie in the gripper rods have come away from the floor.
If you insist on firring with gripper and underlay the correct gripper should be used as described above in this case about all you can do is try rubbing the pins down bending them with a piece of steel rubbed ard under pressure over the pins to try and bend them over.
Continue pulling the carpet off the tack strip by hand until you can fold back the entire wet section.